technodogs:student:notebooks:worthing:techno-pups:development-log:2910-breakdown
- Nidec
- CIM
- 1/4-20 x 1.5“ Hex (2 pcs)
- 1/4-20 x 0.625” Counter Sink Hex (3 pcs)
- Spacer: 1.25“, 0.5” OD, 0.192“ ID
- Spacer: 1.25”, 0.5“ OD, 0.250” ID (2 pcs)
- Spacer: 1.25“, 0.5” OD, 0.3125“ ID
- 1/4-20 x 1.75” Hex (2 pcs)
- 5/16“ washer (3 pcs)
- 5/16-18 x 2.25” Hex
- #10-20 x 0.25“ Hex Button Head (6 pcs)
- 5/16-18 Lock Nut
- #10-32 x 2.25” Hex
- AM-0034; 14 Tooth Gear
- AM-0032; 2mm Key (square)
- AM-2095; 5/8“ Round Bearing
- Vex Versa Wheel DT 4”
- CSCA035; Thin section bearing found at vxb.com
- 6325K86 @ Mcmaster Carr; 48 Tooth Gear
- hub; 0.25“ ID; 0.5” top OD, 1“ bottom OD
- #11-38 x 0.3125” Hex Counter Sink (6 pcs)
- AM-2986; 0.5“ Hex Flanged Bearing
- VexPro 217-3210; 30T Gear, 3/8” Hex bore
- 3/8“ Hex Bore washer, 0.5” OD, 0.0625“ thickness
- F608-2RS @ vxb.com; flanged bearing
- 688-2RS @ vxb.com; bearing (2 pcs)
- AM-0573; Flanged bearing
- AM-0030; Flanged bearing
- 94195A240 @ Mcmaster; self taping screws (6 pcs)
- VexPro 217-5829; hex flanged bearing
- 1/4-20 x 1” hex (2 pcs)
- 91259AB34 @ Mcmaster; shoulder screw
- 3/8“ Hex Aluminum; 2.07” long, 0.4475“ long, lathe cut on one side with 0.133” OD
- #12-22 x 0.5“ Hex countersink (can be replaced with 1/4-20)
- #10-32 x 0.5” button head screw
- Gates 9293-0501 @ rolaysupply.com; belt
- AndyMark CIMcoder
3d print
- both bevel gears ??? (labeled KSB)
- Spacer wheel
- Steel pulley custom
- Base pulley custom
Machining
- Intermediate Shaft
- main plate
- motor plate
- all spacers
technodogs/student/notebooks/worthing/techno-pups/development-log/2910-breakdown.txt · Last modified: 2022/10/01 17:00 by 127.0.0.1