* Nidec
  * CIM
  * 1/4-20 x 1.5" Hex  (2 pcs)
  * 1/4-20 x 0.625" Counter Sink Hex (3 pcs)
  * Spacer: 1.25", 0.5" OD, 0.192" ID
  * Spacer: 1.25", 0.5" OD, 0.250" ID (2 pcs)
  * Spacer: 1.25", 0.5" OD, 0.3125" ID
  * 1/4-20 x 1.75" Hex (2 pcs)
  * 5/16" washer (3 pcs)
  * 5/16-18 x 2.25" Hex
  * #10-20 x 0.25" Hex Button Head (6 pcs)
  * 5/16-18 Lock Nut
  * #10-32 x 2.25" Hex
  * AM-0034; 14 Tooth Gear
  * AM-0032; 2mm Key (square)
  * AM-2095; 5/8" Round Bearing
  * Vex Versa Wheel DT  4"
  * CSCA035; Thin section bearing found at vxb.com
  * 6325K86 @ Mcmaster Carr; 48 Tooth Gear
  * hub; 0.25" ID; 0.5" top OD, 1" bottom OD
  * #11-38 x 0.3125" Hex Counter Sink (6 pcs)
  * AM-2986; 0.5" Hex Flanged Bearing
  * VexPro 217-3210; 30T Gear, 3/8" Hex bore
  * 3/8" Hex Bore washer, 0.5" OD, 0.0625" thickness
  * F608-2RS @ vxb.com; flanged bearing
  * 688-2RS @ vxb.com; bearing (2 pcs)
  * AM-0573; Flanged bearing
  * AM-0030; Flanged bearing
  * 94195A240 @ Mcmaster; self taping screws (6 pcs)
  * VexPro 217-5829; hex flanged bearing
  * 1/4-20 x 1" hex (2 pcs) 
  * 91259AB34 @ Mcmaster; shoulder screw
  * 3/8" Hex Aluminum; 2.07" long, 0.4475" long, lathe cut on one side with 0.133" OD
  * #12-22 x 0.5" Hex countersink  (can be replaced with 1/4-20)
  * #10-32 x 0.5" button head screw
  * Gates 9293-0501 @ rolaysupply.com; belt 
  * AndyMark CIMcoder
3d print
  * both bevel gears ??? (labeled KSB)
  * Spacer wheel
  * Steel pulley custom
  * Base pulley custom
Machining
  * Intermediate Shaft
  * main plate
  * motor plate
  * all spacers
{{:notebooks:worthing:techno-pups:development-log:20180816_163015.jpg?direct&200|}}
{{:notebooks:worthing:techno-pups:development-log:20180816_163025.jpg?direct&200|}}
{{:notebooks:worthing:techno-pups:development-log:20180816_163035.jpg?direct&200|}}